1. General Introduction
The SD83x Power Supply Units are designed to meet all the applicable electrical safety data stated by the EN 50178 harmonized European Standard Publication and the additional safety and function data required by EN 61131-2 and UL 508.
The secondary output circuitry is accepted for SELV or PELV applications. They are switch-mode Power Supply Units which convert the mains voltage to 24 volts d.c. These power supplies can be utilized for non-redundant and redundant applications.
Redundant applications require diode voting units SS823 or SS832. With the type SD83x series Power Supply Units, there is no requirement for the installation of a mains filter. They provide a soft start feature; power-on of an SD83x will not trip fuses or earth-fault circuit breakers.
2. Specification of SD833
General info | |
Article number | 3BSC610066R1 |
Type | Power supply |
Rated output current | 10A |
Rated output power | 240W |
Rated output voltage | d.c. 24 V |
Rated input power | 447/514 VA |
Mains/input voltage, nominal | 100-120 V a.c. 200-240 V a.c. Auto-select input |
Applications | SELV and PELV |
Efficiency | 91/91.6 % |
Detailed data | |
Mains voltage variation allowed | 90-132 V a.c. 180-264 V d.c. |
Mains frequency | 264-300 V a.c. |
Primary peak inrush current at power on | <10 A |
Load sharing | - |
Power Factor (at rated output power) | 0.59/0.51 |
Heat dissipation | 24/22 W |
Output voltage regulation at max. current | < 70 mV / <100 mV |
Ripple (peak to peak) | < 50 mV |
Secondary voltage holdup time at mains blackout | 46/47 ms |
Maximum output current (min) | 12A At ambient temp < 45 °C |
Maximum ambient temperature | 60 °C |
Primary: Recommended external fuse | 10-20A |
Secondary: Short circuit | < 18 A |
Output over voltage protection | < 39 V |
Environmental and certification | |
CE mark | Yes |
Electrical safety | IEC 61131-2, UL 508, EN 50178 |
Protection rating | IP20 according to IEC 60529 |
Corrosive atmosphere ISA-S71.04 | G2 |
Pollution degree | Degree 2, IEC 60664-1 |
Mechanical operating conditions | IEC 61131-2 |
EMC | EN 61000-6-4 and EN 61000-6-2 |
Overvoltage Categories | Over-voltage Category III (IEC/EN 60664-1) |
Equipment class | Class 1 according to EN 50718; 3.56 |
RoHS compliance | EN 50581:2012 |
WEEE compliance | DIRECTIVE/2012/19/EU |
Dimensions | |
Width | 60 mm (2.36") |
Depth | 117 mm (4.02") |
Height | 124 mm (4.88") |
Weight (lbs.) | 700 g (1.5 lbs.) |
Mounting spacing W mm | 15 mm (0.59") |
Mounting spacing H mm | 40 mm (1.57") |
3. Selection table of Power Supply Module
Name | Rated output current | Type |
SD831 | 3A | Power supply |
SD832 | 5A | Power supply |
SD833 | 10A | Power supply |
SD834 | 20A | Power supply |
SD853 | 10A | Power supply |
SD854 | 20A | Power supply |
